WALLBOX Power boost three phases - EM340

WALLBOX dynamic management of your charging power

The dynamic load management module - WALLBOX Power boost three-phase - EM340 allows you to dynamically manage the load of your three-phase Wallbox terminal according to the available power of your installation.

Compatibility

This meter is compatible with terminals Wallbox Copper three-phase and Pulsar Plus three-phase

Main features

• Dimensions: approximately 5x8x4cm
• Front protection degree: IP51
• Backlit LCD screen
• Integrated touchpad
• For DIN-rail bracket
• Built-in counter: yes

Setup

• Enclosure for DIN-rail bracket
• The management module is installed on the switchboard's main power supply
• 4 twisted cables 6/10

Example of use

For example, if you have a 40A single-phase installation at home, and you have connected your Wallbox Copper terminal to 32A single-phase on a dedicated line, then there is a good chance that your main circuit breaker will trip during a load, because your charging station will consume more than the available power.

The load management module will allow you to avoid this problem. It connects to the power supply of your board, and will measure in real time the total consumption of your home. The only setting to indicate to it is that of the amperage of your main switchboard, for example 40A here. The module will then make the difference between 40A and the current consumed, and will continuously supply the terminal with the maximum current available, without tripping the installation.

Thus, if your home consumes 17A, for example, then your terminal will be supplied with 23A (40-17). When your home consumes less, 5A for example, then the terminal will be supplied with 32A (40-5, but limited to 32A, maximum charging current of the terminal).

Link to all WALLBOX charging station

Back to Home Page